5.4.5
Operation of the Fire in “AUTOMATIC” mode
a)
Firstly turn the handset on and light the fire by pressing and holding the
“ON” / “OFF” button on the remote handset for a minimum of 2 seconds
as shown in Fig. 3, section 5.4.4
b)
Press the “THERMOSTATIC” button on the handset below as shown in
Fig. 5, the handset will then switch to “AUTOMATIC” mode and the
“AUTO” icon will appear on the display as shown.
Fig. 5
c)
The large digit temperature display shows the room tempertature that
the handset is sensing at the time. The small digit temperature display
shows the temperature that you wish to achieve in the room. See Fig.
5 above. To adjust, press the “UP” / “DOWN” arrow keys on the
handset. When “AUTO” mode is selected, the remote handset, by
means of an internal thermostat in the hnadset checks the difference in
temperature between the temperature you require and the room
ambient at a fixed time interval. Depending on the difference, the flame
level is modulated to maintain the required temperature. Once the
requested temperature is reached, the flame level is reduced to the
minimum level and remains in this state for a 2 minutes period, then it
will switch to standby mode (pilot only lit) and the “PILOT” icon will
appear on the display. As soon as the room temperature falls below the
set room temperature, the main burner will light and the fire will
modulate between the high and low settings.
“AUTO” Graphic on
Handset Display
“THERMOSTATIC”
Button
Room Temperature
Temperature Required
41
