9
SMART 9 STAGE BATTERY CHARGER
& MAINTAINER
24V 6 AMP
• Equalisation Charging - BLUE Bulk LED and GREEN Absorption LED both
flashing
A well proven process that carefully overcharges the battery to restore it’s full capacity.
The Equalisation stage for CALCIUM Battery type selection is automatic.
The Equalisation stage for AGM&WET and GEL Battery Types only occurs if the initial
start Voltage is below 22 Volts.
• Battery Analysis - GREEN Full LED ON
The battery analysis stage checks the condition of the battery after the charge cycle
is completed. If the battery Voltage drops too quickly during the analysis mode, this
means the battery is probably faulty. If the battery analysis failed, this is indicated by the
GREEN Full LED flashing.
• Float Mode - Full GREEN LED ON
This stage allows you to keep the charger connected 24/7 to ensure your battery is
well maintained and kept 100% fully charged. Float mode will maintain the battery at a
constant 27.2V. DC.
• Long Term Maintenance - Full GREEN LED ON
During long term maintenance / float mode, the unit will apply a special pulse charge to
ensure the battery is kept in optimal condition.
5. Disconnecting the Battery charger from Battery
• If the Battery is out of the vehicle:
(1) Switch OFF and Remove the AC Pin Plug from the outlet.
(2) Remove the BLACK (-) lead and then the RED (+) lead.
• If the battery is still in the vehicle:
(1) Switch OFF and Remove the AC Pin Plug from the outlet.
(2) Remove the BLACK (-) lead from the vehicle chassis.
(3) Remove the RED (+) lead from the battery.
Note: Check electrolyte levels if possible after charging as they may need topping up with
distilled water (This does not apply to sealed maintenance free batteries).
KP87007 Ozcharge manual_OC2406U.indd 9
18/04/2018 2:17 PM