kincrome KP87007 Manual Download Page 6

6

SMART 9 STAGE BATTERY CHARGER  

& MAINTAINER 

24V 6 AMP

TEMPERATURE & SAFETY PROTECTION: 

•  INTERNAL OVERHEAT PROTECTION: The charger has a built-in overheat and an  

overload electronic circuit. This protects the charger from being damaged if overheated 
or overloaded and will automatically decrease the charging current. Once the units  
internal temperature decreases to a safe level, the charger will resume normal charging. 

•  SAFETY TIMER PROTECTION: The charger has safety timers for every stage. If the 

battery Voltage doesn’t reach a certain Voltage within a certain time, the unit will stop 
charging as it’s highly likely that you’re attempting to charge a severely discharged or 
heavily sulphated battery. If any of the stages time out, the charger will immediately 
stop charging in order to protect the battery. This will be indicated  with the fault LED 
flashing slowly. 

•  REVERSE POLARITY: The charger has reverse polarity protection. If the charger output 

leads are connected reverse polarity, the fault LED will come ON and the charger will be 
disabled. Simply unplug  the charger from AC power and then connect the output leads 
to the correct polarity.

•  SHORT CIRCUIT PROTECTION: The charger will automatically turn OFF if the output 

leads are short circuited and the fault LED will come ON. This prevents the charger from 
being damaged if the positive and negative crocodile clips or the optional ring terminals 
accidently touch each other while the charger is turned ON.

•  ECO MODE: This Kincrome Battery Charger has a built in ultra low power consumption 

circuit. If AC power is connected and the battery is disconnected, after 10 seconds the 
charger will automatically go into an ECO mode. During this mode the power drawn 
is less than 0.36W which totals 0.01kWh per day power consumption. If AC power is 
connected and the battery is connected, once the battery is fully charged and during the 
long term maintenance stage, the total power consumption is around 0.03kWh per day. 

 Both the selected Charge rate and Battery type LED’s will flash GREEN to indicate ECO 
mode. 

BATTERY TYPES & CAPACITY:

•  Suits conventional lead acid batteries (VRLA) AGM, Calcium, Gel & Wet.                                           

The Ah (Ampere Hours) capacities shown below are to be used as a general guide only. 
Some batteries may be able to handle a higher charge current. Refer to the battery  
manufacturers specifications and recommendations for your charging requirements. 

Charge Rate:

1A

4A

6A

Charging

3 - 20Ah

12 - 80Ah

18 - 120Ah

Maintaining

< 100Ah

< 120Ah

< 180Ah

KP87007 Ozcharge manual_OC2406U.indd   6

18/04/2018   2:17 PM

Summary of Contents for KP87007













Reviews: