Bench Drill Press ON/OFF switch (Fig. 23)
1.
To turn the drill press ON, insert the yellow
safety key (1) into the switch housing (2). As a
safety feature, the switch cannot be turned ON
without the safety key.
2.
Flip the switch (3) upwards to the ON position.
3.
To turn the drill press OFF, press the switch
downwards.
4.
To lock the switch in the OFF position, remove
the safety key (1) from the switch. Store the
safety key in a safe place.
Light and laser Line ON/OFF switches (Fig. 23)
The light switch (4) is located below the ON/OFF
switch on the left.
The laser switch (5) is located below the ON/OFF
switch on the right.
Position the table and workpiece (Fig. 24)
Always place a piece of backup material (1)
(wood, plywood, etc.) on the table underneath the
workpiece (2). This will prevent splintering on the
underside of the workpiece as the drill bit breaks
through. To keep the material from spinning out of
control, it must contact the left side (3) of the
column as illustrated, or be clamped (4; not
included) to the table.
Note: For small workpieces that cannot be
clamped to the table, use a drill press vise (not
included). The vise must be clamped or bolted to
the table to avoid injury.
VII. Operation
19
Fig. 23
Fig. 24
1
2
3
3
4
2
1
3
4
5
