IMPORTANT SAFETY INFORMATION
The use of vehicle support stands has inherent dangers to avoid risk of personal injury or property damage
make sure you are fully aware of the operating instructions for this product, the recommendations in the
vehicle owners manual for jacking of your vehicle and the safe usage instruction for the jack you will use; all
prior to lifting the vehicle. Do not exceed maximum working load limit of these support stands. These
stands are intended for automotive use only. Be aware that large or heavy vehicles may exceed the stands
stated capacity check vehicle owners manual or contact the vehicle manufacturer. Do not use for any other
purpose accept the supporting of a raised vehicle, never use to support any structure or building, do not
support any human load.
UNPACKING AND ASSEMBLING
Unpacking Carton
Place carton in a clear, open area such as garage floor. Remove support stand bases and upper columns
from carton.
Assembly
Place a base securely on the floor. Insert the upper column into the
lower section of base. Lift the handle and slowly insert the column as
far as it will go. Be careful not to drop the column and be aware to not
trap fingers. Once the column is inserted locate the hole drilled in the
bottom of the upright. Using a small punch and hammer insert the split
pin provided, the split pin will protrude either side of the upper column,
the pin is to prevent the column being removed from the base. Repeat
for both stands.
Raise the column until the desired height is reached, make sure the
handle has returned to its natural position and the pawl has fully
engaged the teeth on the upper column – do not exceed the maximum
height raised of the vehicle support stand.
Preparing Work Area
Before using vehicle support stands and a jack to lift vehicle, it is important to prepare work area properly.
Follow this procedure each time a jack and support stands are used to help prevent property damage and or
serious injury.
1.) Thoroughly inspect vehicle support stands for damage or wear before each use. Briefly test operation of
unloaded stands before using to support any load. If vehicle support stands are damaged or are
