KinAn DL2908i, User Manual

Page: 28 / 95

8 Port /16 Port /24 Port/32 Port
User Manual
- 28 -
5.2 Configuration Setup via Serial Console
For using serial terminal, the KVM-over-IP has a serial line interface (host side).
This connector is compliant with the RS-232 serial line standard. The serial line has
to be configured with the parameters given in Table below.
Parameter Value
Bits/second 115200
Data bits 8
Parity No
Stop bits 1
Flow Control None
When configuring with a serial terminal, e.g., Hyper Terminal, reset the
KVM-over-IP and immediately press th
e “ESC” key. You will see some device
inform
ation, and a “=>” prompt. Enter “config”, press “Enter” key and wait for a few
seconds for the configuration questions to appear.
As you proceed, the following questions will appear on the screen. To accept the
default values shown in square brackets below
, press “Enter” key.
IP auto configuration None/DHCP / BOOTP
）
:
IP address[192.168.0.70]
：
Subnet mask[255.255.255.0]
：
Gateway
（
0.0.0.0 for none
）
[0.0.0.0]
：
IP auto configuration
With this option, you can specify whether the KVM-over-IP should get its network
settings from a DHCP or BOOTP server. For DHCP
, enter “dhcp”, and for BOOTP
enter “bootp”. If you do not specify any of these, the IP auto-configuration is disabled
and subsequently you will be asked for the following network settings.
IP address
The IP address the KVM-over-IP. This option is only available if
IP auto-configuration is disabled.
Net mask
The net mask of the connected IP subnet. This option is only available if IP
auto-configuration is disabled.
Gateway address
The IP address of the default router for the connected IP subnet. If you do not
have a default router, enter 0.0.0.0. This option is only available if IP
auto-configuration is disabled
Warning:
User“super”is forbidden to log in via the serial port of the IP-KVM.