Kimo ATE 310, User Manual

Page: 19 / 24

8. F 520 : Measurement setting
8.1. Add a coefficient
The correction coefficient allows to adjust the transmitter according to data in pressure of the installation.
How to calculate it ?
For example, the pressure in your section is
20 Pa
and the transmitter indicates
18 Pa
. The
coefficient to apply is 20 / 18 it means 1.111.
The transmitter is powered on.
➢
Press OK .
➢
Enter the activation code (see page 9).
➢
Press OK .
➢
Press Up key to go to the F 500 folder.
➢
Press
OK
.
“F 520” flashes, corresponding to the gain setting folder for the channel 1.
➢
Press twice on OK .
The first gain digit flashes.
➢
Enter with Up and Down keys the number value or the negative sign of the value then press OK.
The second digit flashes.
➢
Enter with Up and Down keys its value then press OK.
➢
Perform the same procedure for the following digits.
➢
Press OK when the last digit is configured.
F 520 flashes, the offset for the channel 1 is configured.
To add a gain to the channel 2 , go to the F 530 folder and perform the same procedure as for the channel 1.
To add a gain to the channel 3 , go to the F 540 folder and perform the same procedure as for the channel 1.
8.2. Add an offset
In order to compensate any possible drift of the transmitter, it is possible to add an offset to the value displayed by the
transmitter by entering a value via the keypad.
The transmitter is powered on.
➢
Press OK .
➢
Enter the activation code (see page 9).
➢
Press OK .
➢
Press Up key to go to the F 500 folder.
➢
Press twice the
OK
key then Up key to go to the F 521 folder.
“F 521” flashes, corresponding to the setting folder of the offset for the channel 1.
➢
Press OK.
The first digit of the offset flashes.
➢
Enter with Up and Down keys the number value or the negative sign of the value then press OK.
The second digit flashes.
➢
Enter its value with Up and Down keys then press
OK.
➢
Perform the same procedure for the following digits.
➢
Press OK when the last digit is configured.
F 521 flashes, the offset for the channel 1 is configured.
To add an offset on channel 2 , go to the F 531 folder and perform the same procedure as for the channel 1.
To add an offset on
channel 3
, go to the
F 541
folder and perform the same procedure as for the channel 1.
19
F 520 : Measurement setting