WARNING
• It is recommended to wear full, safety-tested protective equipment and personal protective equipment. Complete protective equipment includes:
helmet, gloves, knee-pads, elbow-pads)
• Ensure that your child has put on a helmet, knee pads and elbow pads before traveling.
• Also, the child should wear comfortable shoes with a rubber sole.
• Before use, carefully read the instructions for assembling a scooter.
• The scooter must only be assembled by an adult.
• Either the scooter assembly must be tested by an adult.
• Before use, you must instruct the child.
• It is forbidden to ride from the slopes and drive into the slope.
• The scooter brake is not designed to brake when rolling from a mountain.
• It is forbidden to travel on this model at a speed of more than 15 km / h.
• Children may use the scooter only under the supervision of an adult.
• Before use, check how tightly all bolts and nuts are tightened.
• Do not recommend for children under 8 years.
• This product complies with European standard EN 14619. The materials used for making this product are suitable and safe for children’s health.
• Do not use in busy streets, with traffic, main roads, uneven hills, uneven and wet surfaces, around pools and stairs. Children must observe the rules of
the road and be careful with pedestrians. The scooter must always be ridden in the right land and overtake from the left side. When they want to join
the traffic, they should signal with their hand, for the other participants in the traffic to see them. The road traffic law applies to scooter riders. It is not
allowed for scooter riders to be pulled by cars, buses and other motor or motorless vehicles.
• Do not make any modifications to the product! Do not change any part of the design of the scooter, because it might result in reducing of the safety of
the product! Do not place or tie any objects or other accessories and strings to it. This may cause hooking, entanglement and loss of balance, resulting in
injury to the child. Do not remove the braking system. Do not use the scooter for jumping over obstacles. The scooter is not suitable for air acrobatics for
scooters, making tricks, riding on ramps, jumps, aggressive riding, riding on rough terrain, riding under severe weather conditions, riding with heavy
loads over the maximum weight capacity of the scooter, carrying loads, renting out; such use is dangerous in its essence, can cause serious injury to the
user and even death!
ASSEMBLING THE SCOOTER
Before assembly, it is recommended to check the availability of all the components of the scooter. To do this, unpack the box, pull out all the
components and lay out on a flat smooth surface.
1. Insert the knobs into the corresponding holes, pressing down on the latch, until a characteristic click
(Figure 1).
2. In order to lay out the scooter, loosen the lock on the frame, take it aside and pull the plastic eccentric.
If you feel that the progress of the steering rack has become freer, lower the deck until it clicks. Then, slightly tighten the nut next to the retainer and
turn it towards the frame (Figure 2).
COMPLETE SCIENCES
In order to fold the scooter, repeat the same steps in reverse order.
STOPPING WITH THE SCOOTER
Do not ride with bare feet. Always wear shoes! The scooter does not have a starting device. It has a stopping device, which does not activate
automatically. Stopping is an important skill and must be acquired in time.
1. Make sure that you hold the handlebar firmly with both hands and move in a straight line. Slide one foot back towards the rear wheel of the scooter.
2. With the heel of this foot gradually apply pressure on the brake mechanism. This will reduce the speed and will finally lead to stopping of the scooter.
WARNING! The breaking mechanism can get heated during use. DO NOT touch the brake after stopping! While using the brake never touch it or the
wheels – during continuous use for reduction of the speed and during stopping their temperature rises and you may burn your hands!
THIS SCOOTER HAS AN ADDITIONAL STOPPING METHOD BY USING THE HAND BRAKE.
STEERING HEIGHT
In order to set the required height of the steering wheel, you need to loosen the clamp of the steering rack of the scooter, pull the steering wheel up /
press it (if you need to lower it) and turn the clamp back (Figure 3).
STORAGE AND CARE
It is recommended to lubricate the bearings and fixings of the scooter.
It is recommended to store the scooter in a dry ventilated area.
ENGLISH
