Page 10 / 14
Product Description
MD15-C, MD15-HR, MD15-DA
3.09-20.115-01-EN | 2019-08-12
Q
►
Place the valve adapter onto the valve and tighten the hexagon socket screw
(see figure 5).
►
Place the actuator on the threaded connection of the valve and tighten hand-tight using the union
nut (see figure 7).
►
Establish the electrical connection.
►
After the line power has been switched on, an automatic initialization run takes place. The
actuator first travels to the upper end position and then to the lower end position.
The actuator will not respond to the control signal until the initialization run is complete.
NOTE
When the unit is remounted, you must adapt the valves again by performing a reinitialization (see
page 14).
%
%
13
14
15
16
