Gear box
Attach the Rear Wheels
1.
Slide a rear wheel onto the axle with
protrusion facing toward vehicle.
Note:
the rear wheel is marked
Rear
and
has a gear-shaped protrusion.
2.
Fit the gear shaped protrusion into
the gear box.
3.
Align the three locating pins on the
inside of the hubcap into the wheel
holes, and push the hubcap into place.
4.
Slide a small washer onto the axle.
5.
Attach nut onto the axle. Using the
hex Wench, tighten snugly until you
can see about two threads on the axle.
Do not over tighten.
6.
Align the pins in the hubcap with the
holes in the wheel cover. Press the
hubcap into place.
Note:
Do not use a
hammer.
7.
Repeat steps 1-6 to attach the
opposite rear wheel.
Side marked
Rear
with
gear-shaped
protrusion
Back-side of
hubcap with
Locating pins
Wheel holes
Side marked
Front
faces towards the car
Attach the Front Wheels
1.
Slide a large washer onto the axle.
Note:
The Washer may already be on
the axle.
2.
Slide a wheel onto the axle with
FRONT
facing toward vehicle.
3.
Slide a hubcap onto the axle, fitting
the three locating pins into the holes in
the wheel.
4.
Slide a small washer onto the axle.
5.
Fasten a nut onto the axle and tighten
snugly with the nut wrench until you
can see about two threads on the
axle. Do not over tighten.
6.
Align the pins in the wheel cover with
the holes in the hubcap.
Press wheel cover into place.
Note:
Do not use a hammer.
7.
Repeat steps 1-6 to attach the
opposite front wheel.
6
Axle
1
2
3
4
5
6
2
1
3
3
4
5
6