10
Unhook the shoulder straps at the rear of the seat shell by
sliding the straps through the slits in yoke (T).
Remove the shoulder straps, pulling them out from the front of the seat.
Press the harness adjuster button (
I
) and pull forward on the
shoulder straps (not the shoulder pads) to completely loosen
the harness.
Ensure you loosen the shoulder straps completely as this will aide the
harness removal.
Note:
The harness adjuster button is located under the seat cover
approximately 4cm above where the adjuster strap (J) exits the seat
cover.
Attention: You should not attempt to adjust the harness height
with a child in the child car seat.
The harness strap slots should be level with or above your
child’s shoulders. If they are not, then you may need to reposition the
harness shoulder straps and adjust the harness height.
The harness should allow 1 finger width (1cm) of space at the
top of the shoulders. This is the ideal tightness. If the harness
is too loose or too tight then adjust the height or tightness
accordingly.
WARNING: The child car seat should always be strapped in using the
vehicle’s seatbelt whether a child is seated in the child seat or not.
Make sure the shoulder straps fit your child snugly by pulling the
adjuster belt (J).
With your child in the seat, match the two halves of the harness
buckles together and insert them into the crotch buckle until
you hear a click.
Note:
Buckle design may vary slightly from that shown.
13
14
15
16
17
18
Adjusting the harness height
Placing your child in the seat - group 1 [9-18kg]
(continued)
Summary of Contents for Group 1,2,3 Car Seat
Page 18: ...16 ...
