31
Step 10: Cafe Wall Assembly
Note: Pre-drill all holes using a 1/8” drill bit before installing the lag screws.
A:
On the ground lay flat 2 (1500) Posts then attach (1874) Side Ground with 4 (H2) 1/4 x 2” Hex Bolts (with lock
washer, flat washer and t-nut); (1501) Floor End using 2 (H2) 1/4 x 2” Hex Bolts (with lock washer, flat washer
and t-nut) in the bottom holes; and (1864) SL Roof Side using 2 (H2) 1/4 x 2” Hex Bolts (with lock washer, flat
washer and t-nut) as shown in fig. 10.1.
Keep bolts loose.
B:
Make sure assembly is square and then fasten (1501) Floor End to (1500) Posts in the top holes using 2
(LS1) 1/4 x 1-1/2” Lag Screws (with flat washer). (fig. 10.1)
C:
Tighten all bolts.
Notice the hole
locations
Wood Parts
Hardware
8 x
1/4 x 2” Hex Bolt (1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
2 x
1/4 x 1-1/2” Lag Screw (1/4” flat washer)
1 x
Floor End 1 x 5 x 38-1/4”
1 x
Side Ground 1 x 5 x 38-1/4”
2 x
Post 2 x 4 x 83”
1 x
SL Roof Side 1 x 4 x 59-1/2”
1501
1864
1500
1874
LS1
H2
1864
1501
Fig. 10.1
1500
1874
1/4” lock
washer
1/4” flat
washer
1/4” t-nut
LS1
H2
H2
LS1
H2
H2
1/4” flat
washer
1500