KIDDY evostar1, Directions For Use Manual

Page: 17 / 179

EN
17
seats, carrycots adaptors etc have been removed from the chassis. Engage the
parking brake.
Ensure the handle is in its lowest position. Ensure the front wheels are unlocked
and in the swivel position. Fully rotate the central section of the handle bar to-
wards you, the hub locks will release (fig. 9; no 1).
Lower the handle towards the floor (fig. 10; no. 2). Lift the carry handle and lift the
chassis upwards to allow the front of the chassis to move towards the rear of the
chassis (fig. 11). Secure the chassis using the travel locks (fig. 12).
3. Seat Unit
3.1. Fitting the seat unit to the chassis.
Important:
Ensure that both the legs are in the same position before attempting
to attach the seat unit to the chassis (fig. 13). Failure to do so may cause damage
to the seat unit.
Insert the seat unit legs into the main housings on the chassis until the seat locks
in place with a click (fig. 14).
WARNING
Ensure the seat unit is locked in place on the
chassis before use.
Note:
The seat unit can be used in forward facing or parent facing modes. Simply
attach the seat unit in the same way in your preferred facing mode.
3.2. Fitting the bumper bar.
Slot the bumper bar into the sockets on the seat unit whilst holding down the
release button (fig. 15).
Important:
Ensure the bumper bar is locked in place
before use by pulling the bumper bar upwards.
17