the label. The date written on the label should be after ten (10) years of cumu-
lative power.
NOTE: Chirping once a minute is an indication of a low battery
where as the indication for replacement is once every 30 seconds.
Battery Replacement
If any form of battery failure is detected the red LED light will flash and the unit
will “chirp” once every minute, and will continue for at least seven days.
Refer to Section 3 for information on installing the batteries.
USE ONLY THE FOLLOWING “AA” BATTERIES FOR SMOKE ALARM REPLACEMENT:
Duracell MN1500, MX1500 or Energizer E91.
These batteries can be purchased at your local retailer.
WARNING! Use only the batteries specified. Use of different batter-
ies may have a detrimental effect on the alarm. A good safety
measure is to replace the batteries at the same time you change
your clocks for daylight saving time.
CAUTION: YOUR SMOKE ALARM IS SEALED AND THE COVER IS NOT
REMOVABLE!
CAUTION! Alarm will not engage to bracket unless all three batter-
ies are installed. Removal of any or all batteries will render the
alarm inoperative!
After installing or changing the battery, reinstall your alarm. Test your alarm by
using the test/reset button and check that the green LED flashes once every 10
seconds.
NOTE: WEEKLY TESTING IS REQUIRED!
WARNING! BE SURE TO FOLLOW BATTERY INSTALLATION INSTRUC-
TIONS PRINTED ON THE BACK OF THE ALARM AND USE ONLY THE
BATTERIES SPECIFIED. USE OF DIFFERENT BATTERIES MAY HAVE A
DETRIMENTAL EFFECT ON THE SMOKE ALARM AND CAUSE IT TO
NOT FUNCTION AS INTENDED.
CONSTANT EXPOSURES TO HIGH OR LOW TEMPERATURES OR HIGH
HUMIDITY MAY REDUCE BATTERY LIFE.
CLEANING YOUR ALARM
YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR
To clean your alarm, remove it from the mounting bracket as outlined in the
beginning of this section. You can clean the interior of your alarm (sensing
0919-7201-02.qxd 1969.12.31 4:15 PM Page 12
