TM206
21 of 35
Issue 1.0
To save the settings, slide the
WRITE ENABLE
switch gently to the right.
Operation of any of detection zone in the range of zones selected to trigger the ECU will put the ECU into
the activated condition.
14.3 Reset
inhibit
time
It is a requirement of the Extinguishing control panel standard EN12094-1 to inhibit reset of the system
after it has been activated until there is a signal representing the end of the discharge (a released input)
or for an adjustable time period of up to 30 minutes. The factory default for the reset inhibit time is 0.
To change the reset inhibit time, switch on the
ENABLE CONTROLS
keyswitch and slide the
WRITE
ENABLE
switch on the module to be configured gently to the left. Press the
ENTER
button on the ECU
then press the
UP
button until the display shows:
Press the
ENTER
button and the display will show:
To change the reset inhibit time, press
UP
or
DOWN
buttons until the time required is displayed and then
press
ENTER
.
To save the settings, slide the
WRITE ENABLE
switch gently to the right.
Resetting of the ECU after it has been activated will now be prohibited until the reset inhibit time has
elapsed.
14.4 Pre-release delay time
The extinguishing control panel standard EN12094-1 allows for a time delay to be set from activation of
the ECU to operation of the Extinguishing release output. This time may be between 0 and 30 seconds
with a maximum of 5 second steps.
The factory default time delay on the ECU is 30 seconds.
To change the pre-release delay time, switch on the
ENABLE CONTROLS
keyswitch and slide the
WRITE ENABLE
switch on the module to be configured gently to the left. Press the
ENTER
button on
the ECU then press the
UP
button until the display shows:
Press the
ENTER
button and the display will show:
To change the time, press the
UP
or
DOWN
buttons until the required time is displayed.
To save the settings, slide the
WRITE ENABLE
switch gently to the right.
The pre-release delay time will now be set to the chosen value.
