1. To insure aesthetic alignment of the
alarm with the hallway or wall, the “A”
line on the mounting bracket should be
parallel with the hallway when ceiling
mounting or horizontal when wall
mounting.
2. After selecting the proper smoke alarm
location as described in Section 1, attach
the mounting bracket to the ceiling as
shown in Figure 3. For wall mounting
see Figure 4. Place the mounting plate
on the wall; be sure the “A” line is
horizontal (parallel to the floor). Use the screws and wall plugs provided to secure
the mounting bracket (use 3/16” drill bit for wall plugs).
3. This alarm has batteries permanently sealed inside the alarm no battery installation is
necessary.
TAMPER RESIST FEATURE
Smoke Alarm Tamper Resist Feature
This alarm is equipped with a tamper resist feature that helps prevent someone from
removing the unit from the mounting bracket. When activated, it can be very effective
in preventing smoke alarm removal or tampering.
NOTE:
The tamper resist feature is automatically engaged whenever the alarm is
mounted to the mounting bracket.
Rotate the alarm onto the mounting bracket
until you hear the tamper resist tab snap
into place, locking the alarm on the
mounting bracket. Using the tamper resist
feature will help deter children and others
from removing the alarm from the bracket.
NOTE: To remove the alarm when the
tamper resist tab is engaged, press down on
the tamper resist tab using a tool such, as a
small screwdriver, and rotate the alarm in
the direction indicated by the arrows on the
cover of the alarm (see Figure 7).
FIGURE 7
A
A
FIGURE 4
When mounting
in a hallway, the
“A” line should
be parallel with
the hallway.
A
A
Alignment Marks
(”A” Line) on
Mounting
Bracket
FIGURE 5
When wall
mounting, the
“A” line should
be horizontal.
3.INSTALLATION INSTRUCTIONS
CAUTION: THIS UNIT IS SEALED (INCLUDING THE BATTERIES). THE COVER IS
NOT REMOVABLE!
Install
Remove
FIGURE 6
A
A
0910-7207-03_R1.qxd:_ 2009.8.13 6:52 PM Page 4
