3
GETTING STARTED
Step 1:
Peel off the plastic film to expose
the non-slip surface of the silicone pads.
Step 2:
Lower your battery into the battery
box base carefully, locating it as centrally
as possible on the non-slip pads.
12 VOLT - 120A/H
www.kickassproducts.com.au
AGM - DEEP CYCLE
VISIT OUR WEBSITE FOR MORE DETAILS
SKU: KAJBABASE | V1.4
POWER STATION
Step 3:
Secure the battery in place by
tightening the velcro strap over the
battery.
Step 4:
Install the battery cables onto the
terminal posts of the battery. Ensure the
red cable is connected to the positive (+)
terminal and black cable connected to
the negative (-) terminal. For DCDC
versions, also connect the thin black
cable to the negative (-) terminal.
Tighten firmly but be sure not to over
tighten the battery terminals.
NOTE:
If your battery box base was
shipped with a battery installed, skip
to Step 3.
Note: the pads may be washed to
regain stickiness.
888
ON
OFF
- Do not Short Circuit
- Do not charge in a sealed container
- Keep sparks and flames away
- Do not leave battery in a discharged state
- Use only fully automatic or regulated chargers
- Discharging below 10.8 volts will void warranty
www.kickassproducts.com.au
CHARGE VOLTAGE
FLOAT USE
CYCLE USE
14.4V - 15.0V (±3mV)
25A
MAXIMUM CURRENT
13.6 - 13.8V
(±3mV)
12 VOLT - 120A/H
AGM - DEEP CYCLE
DCDC TEMPERATURE
SENSOR
