14
Method Two (Mounting on box)
1. Flip the battery box lid upside
down, remove the 6 screws and
carefully remove the cover revealing
the cabling.
2. There is a pre-drilled hole for
cabling on the face of the battery
box, this is covered by the sticker.
Locate this hole on the top of the lid
that is marked by a large dashed
circle. Using a sharp knife, cut the
sticker.
3. The DCDC charger must be suitably
mounted to the lid of the battery box. There
are 4 threaded holes on the top of the lid,
these are located under the smaller dashed
circles. If you wish to make use of these
holes to mount your DCDC charger, again
cut the sticker with a sharp knife. If you
need to drill holes into the battery box lid,
caution must be taken to ensure cables
beneath are not damaged.
888
ON
OFF
4. Crimp Anderson connectors onto the solar and
alternator input wires including the ignition trace wire.
