39
STEERING WHEEL CONTROLS
Headlight position
Parking Light position
AUTO
Auto Light /DRL/
High Beam Assist*
OFF
OFF position
To operate front wipers & washers:
§
Move lever up/down to change wiper modes
MIST:
Single wipe
LO:
Slow wipe
OFF:
Wiper off
HI:
Fast wipe
INT*/AUTO*:
Intermittent*/Auto Rain Sensing*
§
Pull to spray and wipe
To operate rear wipers & washers:
§
Rotate Rear Wiper switch to change Wiper modes
§
Push lever to spray and wipe
Auto Rain Sensing*
The rain sensor located on the upper end of the windshield glass
is designed to sense the amount of rainfall and control the wiping
cycle for the proper interval. The more it rains, the faster the wiper
operates. When the rain stops, the wiper stops.
To turn ON the auto rain sensing wipers, move lever up/down to AUTO. To adjust the auto rain sensing
wiper speed setting, move the speed control switch
A
up/down.
MIST:
Single wipe
OFF:
Wiper off
INT*/AUTO:
Intermittent*/Auto Rain Sensing*
LO:
Slow wipe
HI:
Fast wipe
HI
LO
OFF
Front & Rear Windshield Wipers & Washers
§
When the Engine Start/Stop button is in the ON position and the wiper switch is in AUTO mode, the wiper will automatically
operate once to perform a self-check of the system
§
Set the wiper to the OFF position when the wiper is not in use
§
Moving lever to HI increases intermittent wipe frequency and wipe speed. Moving lever to LO decreases frequency of wipes
§
Pressing button
A
up increases Intermittent wipe frequency and wipe speed. Pressing button
A
down decreases frequency of wipes
§
On Rear Wipers, intermittent wipe function is not adjustable
QUICK TIPS
WIPER SERVICE
MODE VIDEO
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to page 2
for more information.
www.youtube.com/KiaFeatureVideos
QR CODE
A
To lift the windshield wipers to clean the windshield, inspect or replace wiper
blades or raise the wipers in snow/ice conditions without damaging the hood,
the blades need to be moved to the service position
C
.
With the ignition ON, turn the ignition OFF, and within 20 seconds move the
wiper switch up to the MIST position
B
and hold the switch for more than
two seconds until the wiper blade is in the fully up position.
To return wipers to the normal position, turn the ignition ON, then activate MIST.
Image for illustrative purposes only.
See section 7 in the Owner’s Manual for more
information.
Lifting Wipers (Wiper Service Mode)
C
B
ST
EER
IN
G W
HEEL
CON
TR
OL
S
See section 4 in the Owner’s Manual for more information.
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE
OPERATING INFORMATION AND SAFETY WARNINGS.
*IF EQUIPPED
