Kia K2500 2014, Owner'S Manual, Page: 187 / 262

6 23
In case of an emergency
1
2
3
4
5
6
7
8
9
9. Securely tighten the valve of the
jack with the groove on the jack.
10. Move the jack handle up and
down until the top of the jack con-
tacts the proper point and takes
on a slight load, raising the vehi-
cle until the tyre just clears the
ground. This measurement is
approximately 30 mm (1.2 in).
Before removing the wheel lug
nuts, make sure the vehicle is
stable and that there is no
chance for movement or slip-
page.
11. Remove the wheel lug nuts by
turning them counterclockwise,
then remove the wheel.
12. Mount the spare tyre into position
and install the wheel lug nuts
with the beveled edge inward.
13. Gradually loosen the valve of the
jack with the groove on the jack
handle to lower the vehicle.
✽ ✽
NOTICE
If the valve is loosened by turning it
2 or more times in the counterclock-
wise direction, the jack’s oil will leak
and the jack cannot be used.
1PUA4018 1PUA4019
CAUTION
This jack is hydraulic, and the
ram is a two-stage type. When
both rams are raised and the
“stop mark” of the upper ram
becomes visible, stop jacking
immediately.