5
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Ruckus
™
Worktable
Assembly Instructions
11. With two or more people helping,
carefully turn the worktable to the
upright position.
Note:
Worktable doors may be
ordered with right- or left-hand
hinges. The instructions below and
Figures 8 & 9 outline installation
of right-hand hinged doors (left not
shown).
12. Determine whether the doors to
be installed are right- or left hand
hinged, and follow the instructions
below accordingly. At the door
opening side opposite to where
door hinges will install, orient
two door stop brackets over the
pre-drilled holes in the inside of
the cabinet. Secure brackets to the
cabinet using two #10 x
1
/
2
” Phillips
screws per bracket as illustrated
(Figure 8).
13. On the opposite side of the opening
to the door stop brackets, loosely
fasten two hinge plates to the
unit using two #10 x
1
/
2
” Phillips
screws. Orient the hinge plate such
that the tail of the plate is pointing
inside the unit (Figure 8).
14. One at a time, lay each door
down on a soft, protective surface
adjacent to where it will install.
Position the door such that the door
lock will install up. Locate door
hinges from hardware pack, orient
in position as illustrated over door
hinge mounting locations, and
secure each hinge to door using
two #8 x
1
/
2
” Phillips flat-head
screws (Figure 8).
15. Rotate the door up into position
into the door opening, insert the
hooks on the hinge into the front
of the hinge plates. Press the back
of the hinge into the tail of the
hinge plate until it snaps in place.
Position the door to create a
1
/
8
”
gap above and below the door
then tighten the two hinge screws
holding each hinge to the unit
(Figure 9 & Detail B).
Note:
Adjustment of hinges may
be necessary to achieve even
spacing and correct depth of the
door in the workstation opening.
See instructions on the next page.
Figure 8
#10 x / ”
1
2
Phillips
screws
door stop
bracket
end
panel
center
panel
door
hinge
#8 x / ”
1
2
Phillips flat
head screws
door
#10 x / ”
1
2
Phillips
screws
hinge
plate
Figure 9
end
panel
center
panel
door
hinge
hinge
plate
door
hinge
plate
door
hinge
door
Detail B
