3
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Ruckus
™
Worktable
Assembly Instructions
6. To install the base, first position it
onto the installed end and center
panels as illustrated, while aligning
and inserting the divider panel
“teeth” through the slots in the base.
Locate the six oblong holes in the
bottom reinforcements of the base,
then secure the base to the center
and end panels using six
5
/
16
-18 x
1
/
2
” bolts, two into each
panel (Figure 4).
7. At two mounting hole locations near
the center of the base, insert and
tighten two #10 x
1
/
2
” Phillips screws
through the base and into the center
panel (Figure 4).
8. Twist in and tighten one glide to
each corner at the underside of the
base. If casters were specified (not
shown), twist in to install two locking
casters by one pair of doors and
non-locking casters at the other side.
Use a wrench to tighten the jamb-nut
between the caster and base
(Figure 5).
5
1
/ - 18 x / ”
16
2
bolt
center
panel
end
panel
end
panel
#10 x / ”
1
2
phillips
screw
Figure 4
base
teeth of
divider
panel
base
slots
Figure 5
base
glide
teeth of divider
panel set into
base slots
glide
