2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Ruckus
™
Worktable
Assembly Instructions
4. One at a time, position a divider
panel with the two “teeth” pointed up
as illustrated. Insert the panel down
between the installed end and center
panel at the mounting holes in the
middle of the panels. Position the
panel so the mounting holes in the
ends of the divider panel align with
the mounting holes in the middle of
the end and center panels (Figure 2).
Assure also that the mounting holes
align where the divider meets the
pre-drilled holes in the worksurface
underside, or the panel must be
moved over to the next set of holes
so all align properly (Figure 3).
5. Using six #10 x
1
/
2
” Phillips screws
(three at each side) secure the divider
panel to both the end and center
panels. Then, using two #10 x
1
/
2
”
screws, secure the divider panel to
the underside of the worksurface.
Repeat steps 4 and 5 above for
second divider panel (Figure 2 & 3).
Figure 2
end panel
center
panel
end panel
divider
panel
divider
panel
divider
panel
“teeth”
table top
#10 x / ”
1
2
phillips
screw
#10 x /
1
2
phillips
screw
end
panel
center
panel
end
panel
Figure 3
divider
panel
divider
panel
