21
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
RoomScape
®
Residence Hall Furniture - Optional Accessories
Assembly Instructions
Sliding Keyboard Tray Assembly
1. Remove all parts from box:
Parts include :
• One plastic keyboard tray
• Two extension slides
• Four angle brackets
• Four #10-32 x
3
/
8
” binding head
Phillips machine screw
• Four #10-32 hex nuts
• Four #10 lock washers
• Four #8 x
3
/
8
” truss head Phillips
tapping screws
2. Place keyboard tray face down on
table surface.
3. Position extension slides so that tabs
with slots are placed into cutouts on
lower edge of keyboard tray
(Figure 19).
4. Put tapping screws through slots in
extension slide tabs and screw into
holes in keyboard tray. Do not tighten
(Figure 19).
5. Press extension slide firmly against
side of keyboard tray and tighten
tapping screws (Figure 19).
6. Repeat for other extension slide.
7. Select position for angle bracket
and place in position against
extension slide. When using
the hole shown in the diagram,
there will be approximately 3
3
/
4
”
clearance from the bottom of the
table/desk surface to the surface
that the keyboard rest on. The
keyboard surface may be moved
1
/
2
” or 1” closer by using one of the
other two available holes
(Figure 19).
8. Insert machine screw through hole
in angle bracket and bracket on
extension slide. Slide lock washer
over machine screw. Turn nut onto
machine screw and tighten
(Figure 19). Repeat for other three
brackets.
9. Determine the location of the tray
assembly to be installed.
10. Drill corresponding pilot holes to
the pattern formed by the bracket
slots taking care to not drill too
deep, piercing the surface
(Figure 20).
11. Attach the tray assembly by holding
it up to the bottom surface of
the table/desk top and inserting
screws (not included) into the top
(Figure 20).
12. It is recommended that at least four
screws (one for each angle bracket)
be installed to adequately secure
tray assembly to table/desk surface
(Figure 20).
keyboard tray
lock washer
angle bracket
extension slide
Figure 19
#10-32 x /
machine screw
3
8
"
#10-32
hex nut
#8 x /
tapping screw
3
8
"
Figure 20