20
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
RoomScape
®
Residence Hall Furniture - Optional Accessories
Assembly Instructions
#8 x / screw
"
5
8
#8 x / screw
"
5
8
#8 x / screw
"
5
8
rubber bumper
(rear)
handle
CPU
front bezel
CPU holder
vinyl
feet
buckles
strap bracket
rubber bumper
(front)
front edge of worksurface
track
end cap
(track guard)
Figure 18
6. Using a power drill and a
1
/
8
” drill
bit, drill eight pilot holes,
5
/
8
” deep
in the underside of the worksurface.
Do not drill deeper than
5
/
8
” to
avoid piercing the top of the
worksurface.
7. Mount the track to the underside of
the worksurface at the six outside
mounting holes using the #8 x
5
/
8
”
screws provided. Press a rubber
bumper onto a #8 x
5
/
8
” screw and
install bumper into the rear, center
hole in track. Make sure all screws
are tight (Figure 18).
8. Slide the assembled unit and CPU
into the groves on the track until
it stops at the rear rubber bumper.
Press a rubber bumper onto the
remaining #8 x
5
/
8
” screw and
install the bumper and screw into
the front, center hole in the track
(Figure 18).
9. Position the end cap (track guard)
in front of the track at the underside
of worksurface. Mark the two
mounting hole locations
(Figure 18).
10. Using a power drill and a
1
/
8
”
drill bit, drill the two pilot holes
5
/
8
” deep in the underside of the
worksurface. Do not drill deeper
than
5
/
8
” deep to avoid piercing the
top of the worksurface.
11. Mount the end cap (track guard) to
the underside of the worksurface
with two #8 x
5
/
8
” screws
(Figure 18).
