15
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
RoomScape
®
Furniture System - Optional Accessories
Assembly Instructions
Optional Accessories - Hang-On
Shelf Unit, Hang-On Coat Rack &
Hang-On Dresser
1. Hook the unit into the slots in the bed
frame above a worksurface, or at any
desired location. Mount both sides of
unit at the same time and press down
to securely engage mounting hooks
into frame (Figures 8 & 9).
Hang-On Worksurface
1. Locate and determine right- and
left-hand cantilever brackets as
illustrated (Figure 8).
2. Determine correct height for hang-on
worksurface, then one at a time hang
both cantilever brackets into position
on the bed frame, both at the same
height. To secure cantilever bracket
into position, first tip the bracket at
an angle to the bed frame and hook
the top locking tab first. Then rotate
the bracket down to allow other teeth
into slots in bed frame and push
down firmly to secure (Figure 8).
3. Place the worksurface on top of the
cantilever brackets, align mounting
holes of worksurface with those
of brackets and secure using four
thumb screws (Figure 8).
Drafting Board
1. Drafting board can be placed on any
worksurface (Figure 8).
Task Light
1. Task light (Figure 8) installs under
hang-on shelf or hang-on flipper
door unit. See instructions on
page 18
.
Cord Manager
1. Hook the cord manager into the slots
in the bed frame, below a task light,
or any place electrical cords are
present to be held in place
(Figure 8).
2. Hide the cords by pushing them into
the open edge of the cord manager
(Figure 8).
CPU Sling
1. CPU Sling (Figure 9) installs under
any worksurface. See instructions on
page 19.
Free-Standing Wardrobe
1. Wardrobe unit can be positioned
up against either bed end frame,
or placed at any location in room
(Figure 9).
Stack-On Wardrobe
1. Position stack-on wardrobe on top
of free-standing wardrobe, lining up
clearance holes in top of free-standing
wardrobe with weld-nut holes in
bottom of stack-on wardrobe
(Figure 9).
2. Fasten the two units together securely
using four thumb screws from inside
the free-standing wardrobe
(Figure 9).
hang-on
shelf unit
hang-on
worksurface
task
light
cord
manager
cantilever
bracket
(right-hand)
cantilever
bracket
(left-hand)
thumb
screws
drafting
board
Figure 8
stack-on
wardrobe
free-standing
wardrobe
hang-on
coat rack
CPU
sling
Figure 9
