Backbone
®
Media Platform
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
3
access door and secure the
modules to the table top
from inside the enclosure
unit with provided fasteners.
Place the switching box
inside the larger end (left
side) of the enclosure. Begin
by plugging in all like wires
one at a time, (audio, video
or control) into the respective
locations on the switcher.
Start with the module that
is farthest from the switcher
(small end of enclosure)
and route its wire(s) through
the “bottom” opening in the
center divider wall of the
enclosure unit. Continue to
route all wires through the
bottom opening until you
reach the wires coming from
a module located beyond the
center divider. Take care to
make sure audio/video wire
that may need to move in and
out of modules reach there
desired locations. After all
control wires have been run,
complete wiring by plugging
in 110v electrical wires to the
power strip
Access Door Installation
12. Position access door as
illustrated with tabs facing
down and towards the inside
of unit (Figure 5).
13. Lift door up and tilt away
from unit so that the tabs can
slide into opening, make sure
tabs are positioned correctly
(Figure 5 & Detail B).
14. Push door in and against pre
installed tabs so the outside
is flush with the rest of the
unit (Detail B).
15. Place keys into pre-installed
key locks on access door and
turn them so that the door is
locked into place and does
not fall out (Figure 5).
10. Carefully lift and rotate the
assembled table top right
side up onto the enclosure
unit. The enclosure unit
has several pre-installed
“top fastening brackets”,
which align with pre-drilled
holes on the underside of
the assembled table top.
Move the top around on the
enclosure unit until all of
the holes in the fastening
brackets align with the
pre-drilled holes in the
underside of the table
top. Secure top fastening
brackets to underside of
table top using #12 x
5
/
8
”
wood screws provided
(Figure 4).
Switching Hardware
Assembly
11. Place all table top modules
into the cutouts in table top,
making sure to orientate
each in the correct direction.
Route all wires out the
