20
IV. WHEELCHAIR USE & CONFIGURATION
I. Height Adjustable Flip Back T-Arm (Continued)
2. Increase/Decrease the Front End Length of Armrest
The armrest pad is not centered on the tube, widthwise or lengthwise. This offers two different
length options - longer or shorter on the front end of the chair. This also offers two options with
the armrest pad. When the long end of the armrest is on the front end of the chair, the armrest
pad hangs more to the outside of the chair. The armrest pad hangs more to the inside of the
chair when the short end of pad is on the front end of chair. The armrests can also be switched
to the opposite sides to allow more options regarding the amount of front end pad length and
side pad length.
a. Pull the height adjustment lever (Fig. 5:A) and remove the upper T-Arm assembly (Fig. 5:B).
b. Rotate the upper T-Arm assembly and reinstall into the armrest.
c. Close the height adjustment lever (Fig. 5:A) to secure.
3. Increase/Decrease the Height of the Armrest
Each hole on the upper T-Arm assembly bar represents a height setting that can be used ½"
(1,27 cm) increments.
a. Pull the height adjustment lever (Fig. 6:A) and slide the upper T-Arm assembly to the
desired height.
b. Close the height adjustment lever (Fig. 6:A) to secure.
A
B
Fig. 5
A
Fig. 6
