28
3.1.9 Voltage display module and DC head installation
Figure 3.1.33 Shematic diagram of voltage display module and DC head installation
We need to use two power cables (the same as the wires used by the motor, one red and one black), and
connect the two wires to the DC power supply head. DC power supply head as shown in Figure 3.1.34.
You need to remove the rubber ring at the "1" mark to open the caser and solder the wire to +12V and GND,
as shown in Figure 3.19.3.
Figure 3.1.34 Shematic diagram of solder DC power supply head
Summary of Contents for Hummer-Bot-1.0
Page 1: ...Hummer Bot 1 0 Instruction Manual V 2 0 ...
Page 18: ...15 Step4 You need to install motors Figure 3 1 5 Schematic diagram of motor installation ...
Page 50: ...47 Figure 3 2 15 Diagram of Data without Obstacles ...
Page 83: ...80 Test code Path hummer bot Lesson ModuleDemo IrkeyPressed IrkeyPressed ino ...
