4
4
CONTROL PADS ON THE DEHUMIDIFIER
Control pads
3
3
When you push the button to change
operation modes, the unit will make
a beep sound to indicate that it is
changing modes.
NOTE:
The control panel of the unit you purchased may be slightly different according to the
models.
Fig.1
Fan Pad
Control the fan speed. Press to select either High
or Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set
the fan control to Normal.
2
2
Filter Pad
The check filter feature is a reminder to clean the
Air Filter for more efficient operation. The Filter
light(Clean filter l ight) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press
the Filter pad and the light will go off.
5
5
Humidity Set Control Pads
7
7
: Down/Up Pads
TIMER Set Control Pads
Use the Up/Down pads to set the Auto
start and Auto stop time from 0.0 to 24.
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the pad and set to a lower
percent value(%).
For damper air, press the pad and set a higher
percent value(%).
3
3
Auto defrost operation on
indicator light
High fan
indicator light
Filter
Pump
Fan
Timer
Filter
Full
Pump
On
Off
Turbo
Auto defrost
1
1
2
2
4
4
5
5
6
6
7
7
Clean filter
indicator light
Bucket full
indicator light
Pump operation
on indicator light
Timer on/off
indicator light
1
1
Pump Pad
Press to activate the pump operation.
NOTE: Make sure the pump drain hose is installed
into the unit and the continuous drain hose is removed
from the unit before the pump operation is activated.
When the bucket is full,the pump starts to work.Refer
to the next pages for removing the collected water.
Do not use this operation when the outdoor temperature
O
O
is equel to or less than 0 C (32 F).
4
4
Power Pad
Press to turn the dehumidifier on and off.
Cont.
Continuous
operation on
indicator light
Continuous Operation
To run the unit in continuous mode, press the
pad until the display reads 35% RH. Then press
the pad again until the display reads CO for
continuous operation. To stop continuous operation,
press the and set the desired % RH set point
level to resume nominal operation.
