OIF CEI 3.1 Compliance and Debug Application Getting Started
53
Installing N109228CA and N1010A FlexDCA on a PC
2
Starting the N109228CA OIF CEI 3.1 Compliance Test Application
After you install the N109228CA OIF CEI 3.1 Compliance Test Application on a PC along with the
N1010A FlexDCA interface, start the N109228CA OIF CEI 3.1 Compliance Test Application in one of
the following ways:
Access the N109228CA OIF CEI 3.1 Compliance Test Application directly from the Start menu
Refer to
“Starting the N109228CA OIF CEI 3.1 Compliance Test Application”
procedure to start the application directly (that is, without launching the N1010A FlexDCA Software)
is described.
Access the N109228CA OIF CEI 3.1 Compliance Test Application using the N1010A FlexDCA Software on
your PC
1 Ensure that the N1010A FlexDCA Software is connected to the Oscilloscope. Refer to the earlier
sections for steps.
2 After a connection between the N1010A FlexDCA Software and the Oscilloscope is established,
the N1010A FlexDCA Software on your PC may indicate that it is remotely controlled, as shown in
Figure 50
N1010A FlexDCA Remote App under Remote Control
To view the N1010A FlexDCA's main menu, click the
Local
button (towards the upper right
corner).
Figure 51
N1010A FlexDCA under Remote Control
