Keysight M5200A, Startup Manual

Page: 39 / 80

M5200A PXIe Digitizer Modules Startup Guide 39
Setting up the M5200A module 2
2.2.7: Powering up the Chassis and Remote Controller PC
When powering up the system, the chassis should be powered up first.
After powering up the chassis, you should wait at least three seconds
before powering on the PC. The chassis front panel temperature LED,
which is on for three seconds after the chassis is powered up, provides a
convenient way to measure this delay.
1 Make sure that the line cord is plugged into a grounded outlet to
establish earth ground.
Figure 9 Establishing earth ground to the chassis
2 Make sure all cable connections are secure and modules/controller
inserted properly.
3 Press the power button on the chassis.
The temperature LED, which is on for the first three seconds after the
chassis is powered up, can be used as an indicator of when to power on
the PC. When the LED goes off, the PC can be powered on.
4 Power on the PC.
NOTE
The images above shows generic module installation. It may not reflect
your module’s actual size and chassis placement.
CAUTION
If you are using a remote controller and you have installed the interface
cable, you must power up the chassis before you power up the PC. When
you power down your chassis, shut down the PC before you power down
the chassis.