6
Installation Note N8985-90001
Upgrade Procedure
Upgrade Procedure
1.
Replace the Windows 7 drive with the new Windows 10 drive included in this upgrade kit
using the following instructions. If you have not done this before, or you want to see a graphic,
refer to “Removing and Replacing the Hard Disk Drive (HDD),” located in chapter 7 of the
Service Guide.
a.
Power off the PNA.
b.
Remove all USB devices except the mouse and keyboard from the PNA.
c.
Remove the power cord from the PNA.
d.
Loosen the thumbscrew on the installed SSD and remove the SSD from the drive bay of the
CPU board assembly.
e.
Insert the new, supplied SSD into the drive bay of the CPU board assembly and hand
tighten the thumbscrew on the SSD.
f.
Reinsert the power cord to the PNA.
g.
Verify that there are no USB devices connected to the PNA except a mouse and keyboard.
h.
Power on the PNA.
2.
The PNA will go through its initialization process. This will take about 10 minutes and may
involve as many as five reboots. Do not proceed until all activity has stopped.
3.
The touchscreen will likely be uncalibrated and reversed left-to-right – this is normal.
Calibrate the touchscreen by pressing System > Touchscreen > Calibrate Touchscreen. Follow
the instructions displayed.
4.
If desired, copy any files you saved earlier to their new locations on the Windows 10 drive - see
Table 2 on page 5
.
The opening of covers or removal of parts may expose dangerous
voltages. Disconnect the instrument from all voltage sources while
it is being opened.
Power off your PNA, and unplug the AC, before replacing any assemblies.
The network analyzer must be in proper working condition prior to
installing this option. Any necessary repairs must be made before
proceeding with this installation.
