14 | Keysight | Millimeter Wave Network Analyzers (N5290A/N5291A) - Cofiguration Guide
Measurement Applications
On wafer applications
To configure the system for use with a Cascade probe station a set of 1.0 mm cables are
required as well as a probe positioner. The N5293A module positioner may be obtained
directly from Cascade Microtech for the probe station type.
For currently available 1.0 mm cables see the accessories section below.
It is recommended that a 10 cm long, 1.0 mm (m-f) cable be used with the probe
positioner on the Summit 12K probe station from Cascade. This length is optimized for
the probe positioner and the Infinity 110 series probes from Cascade.
For a guaranteed installation, verification, and support of a probe station based
configuration consider the
Keysight’s Wafer-level Measurement Solution
program used
in conjunction with the N5290/91A millimeter wave network Analyzer.
Materials measurements solutions
The N5290/91A system can be configured to make material measurements at millimeter
wave frequencies. Add the following to the N5290/91A configuration for free space
measurements at millimeter wave frequencies;
1. N1500A materials measurement suite
2. A set of 1.0 mm to either W or V-band adapters, the V281C or W281C listed in the
measurement accessories section
3. A set of V- or W-band horn antennas
4. Thomas Keating quasi optical positioner or a Swiss to 12 corrugated waveguide fixture
N1500A materials measurement suite
The N1500A-001, UL8 materials measurement suite calculates the permittivity and
permeability of material samples placed in a coaxial airline or a rectangular waveguide.
The measurement technique works well for solid materials that can be machined to fit
precisely inside a transmission line. Measurement results can be viewed in a variety of
formats (r’, r”, μ’, μ”, tan d, or Cole-Cole μ). The software can be run on the PNA analyzer
or on a PC.
For additional information or to configure a solution for materials measurements visit:
www.keysight.com/find/materials
Antenna measurements solutions
The broadband N5290/1A single sweep systems are capable of supporting antenna
characterization up to 120 GHz without reconfiguring the hardware. Additionally, you can
customize the most cost-effective solution specific for your application by purchasing
just the module and frequency range you need. More information see “Keysight’s
Antenna Test selection guide” literature number 5968-6759E.
To customize the N5290/91A for banded waveguide measurements refer to the “Banded
Millimeter Wave Network Analysis to 1.5 THz” technical overview literature number
5992-2177EN.
N5293A Frequency extenders mounted on a Cascade
Summit 12K probe station
Цены и срок поставки уточняйте на сайте
, по телефону:
+ 7 495 215-57-17
или
