NETCOM6P/ACU RN (Encrypted) Installation Guide
11
Program the Control Board with a Host-Location IP
Address
You will program the control board with the IP address of the router, endpoint or PC/server
at the host location depending on the network configuration. This allows the control board
to initiate communication back to the host location.
Steps to Program the Control Board with a Host-Location IP Address
1.
Ensure that the access control board still has power.
2.
Do one of the following steps depending on the PC109x version of control board:
J16 Jumpers - Remove the jumpers from J16—pins F & G. And then place a
jumper on J6 momentarily to reset the control board and then remove the
jumper.
S2 DIP Switches – Turn S2 – switches 7 and 8 OFF. And then press and release
the S1 switch.
3.
Return to the PC/laptop with the NETCOM Program Tool Utility. From the Keyscan
NETCOM Utility screen, select the Keyscan Hyper Terminal button.
4.
In the Open Comm Port Selection screen, select the COM port on the PC laptop
connected with the access control board.
5.
Set the Baud Rate to match J16 or S2 on the access control board.
6.
Select the Open Port button.
Continued on the next page…
