NO.
Disassembly order and method
Remark
1
2
3
4
5
6
7
8
☞
Pull out the three #80 screws (M4*25) by turning them to the left with a
(+) screwdriver. Remove #78 bolt by turning it to the left with a 5mm L-
wrench and #79 bolt by turning it to the left with a 6mm L-wrench and
detach #74, #77 handle.
☞
Pull out the black stator lead wire and capacitor from the #1 terminal of
the #76 switch and red wire and capacitor from #2 terminal by turning
with a (+) screwdriver. (See the picture of the
connection terminals
of the upper switch
)
☞
Pull out the two #67 screws (M4*20) by turning them to the left with a
(+) screwdriver and detach the #66 end cover.
☞
Pull out the #60 brush cap by turning it to the left with a (-) screwdriver
and detach the #74 carbon brush. (Do the same for the opposite side)
☞
Pull out the four #59 screws (M6*55) by turning them to the left and
detach the #58 housing from the #47 gear cover.
☞
Detach the # 55 fan guide from the #58 housing.
☞
Pull out the two #57 screws (M5*55) by turning them to the left with a
(+) screwdriver and detach the #56 stator from the #58 housing. (As
the stator is pressed hot, reassembling must be done after heating the
housing with a hot air blower)
☞
After replacing the stator or housing, proceed with reassembling in
reverse order of disassembling.
[Caution 1]
♠
When reassembling the
handle, be careful to
avoid the wire from being
pinched.
♠
See the
switch
connection
picture.
[Caution 2]
♠
Be careful not to
damage #60 brush cap.
[Caution 3]
♠
When reassembling, be
careful not to lose #54
rubber packing.
[Caution 4]
♠
Be careful not to lose
#71 damper (A)
assembly, capacitor and
#73, #75 nut.
- 14 -
78
79
80
Switch
connection
terminals
71
56
66
57
59
55
47
58
60
64
67
77
76
75
73
Switch connection
74
54
