Key Digital KD-MLV4x2Pro, Operating Instructions Manual

Page: 5 / 29

3
Application Examples
IR Emitter Control
When using an IR Emitter / IR Extender (sold separately), the IR Emitter must be mounted over
the IR Sensor on the front of the KD-MLV4x2Pro. One end of the cable is connected to the IR
Receiver/ Master Controller / IR Extender / IR Connecting Block, while the other end is mounted
over the IR Sensor of the KD-MLV4x2Pro.
Serial IR Control
As a more robust alternative to optical IR, KD-MLV4x2Pro may also be controlled via hard-wired
IR. Use a 3.5mm Male Mono plug with the IR Signal carried on the tip of the connector.
Rack Mounting
Secure the rack ears to each side of the KD-MLV4x2Pro with the supplied hardware then fasten
the unit to the rack rails with the included machine screws.
Display 1: Fullscreen Mode
Display 2: Quadrant Mode
Display 1: MultiView Mode
Display 2: MultiView Mode
Signage PC 1
Mac Mini
Digital Signage
VGA Laptop
VGA L/R
HDMI
HDMI
HDMI
Signage PC 2
HDMI HDMI
L/R
HDMI
HDMI HDMI HDMI HDMI
Network
Router
Master Controller
RJ45 WiFi
RS-232
Network
Router
RJ45 WiFi
Satellite/Cable
Game 1
Satellite/Cable
Game 2
Satellite/Cable
Game 3
Satellite/Cable
Game 4
Game 1
Game 2 Game 3 Game 4
Game 1
Game 2 Game 3 Game 4
KD-ProCL1
Key Digital
®
App
KD-MLV4x2Pro KD-MLV4x2Pro
KD-MC1000
KD-X222PO
KD-AMP220
2 Ch Amplifier
CAT5e/6
HDMI
KD-X222PO
CA
T5e/6
KD-MLV4x2Pro
Bar/Restaurant