22
EN
The control board has several micro-switches to activate a lot of functions in order to find suitable solutions for the user and to make the
installation more safety.
3
Operating and regulation modes
3.1 Logic Function
1 2 3 4 5 6 7 8 9 10
DIP
1-OFF 2-OFF
AUTOMATIC 1
By each control it reverse. It recluse automatically at the end of the
pause time.
1-ON 2-OFF
COLLECTIVE USE
When opening and in pause time it doesn’t accept any control, it
reclose automatically at the end of the pause time.
1-OFF 2-ON
PARTIALLY
AUTOMATIC
Each control the sequenze is
OPEN-STOP-CLOSE-STOP
etc. It
doesn’t reclose automatically.
1-ON 2-ON
AUTOMATIC 2
By each control the sequence is
OPEN-STOP-CLOSE-STOP
etc.
It reclose automatically at the end of the pause time
3
4 5 6
8 9 10
1 2
7
3
4 5 6
8 9 10
1 2
7
3
4 5 6
8 9 10
1 2
7
3
4 5 6
8 9 10
1 2
7
3-ON
Man Present
“MAN PRESENT “ function activate
Par. 3.2
4-OFF
Lamp
DIP4 OFF if in the terminal board no.15 and 16 is connected to a
SIGNAL LIGHT
4-ON
External
Brake
DIP 4 ON If the terminal board no.15 and 16 is connected to a
mechanic brake.
6 se DIP 4 OFF
Pre-lightin
It activate the pre-lighting before the gate’s moving
6 se DIP 4 ON
exterior
brake
Put the DIP in ON if the brake has been activated
or in OFF if it is activated when it is not powered.
7-ON
Internal
Brake
To activate the electronic brake put DIP 7 IN on. WARNING!!!
The inside brake is activated for a while after the motor stops
9-ON 10-ON
Radio partial
opening
If you put the DIP 9 and 10 in ON, you can activate the radio partial
opening (10 poles molex connector).
If you use this function, terminal boards OUT2 should be free.
3
4 5 6
8 9 10
1 2
7
3
4 5 6
8 9 10
1 2
7
4 5
8 9 10
1 2
7
4 5
8 9 10
1 2
7
4 5 6
8 9 10
1 2
7
4 5 6
8
1 2
7
6
3
6
3
3
3
7
9
3
4 5 6
8 9 10
1 2
7
10
3.2
MAN PRESENT
If you put the DIP3 the OPEN and CLOSE function changes and also the input for photo-beams
The controls OPEN and CLOSE can be “man present“ function. It means that when the control will be
relased the motor stops immediately.
The controls START/PEDESTRIAN have an automatic function, if the control OPEN and CLOSED are in
use, the control unit won’t accept any control START /PEDESTRIAN untile the gate is closed.
During the “man present” function all safeties are checled but not the obstacle detection. The photo-beams
input is always checked (when the gate is open,too). The gate will stop until the contact is closed.
3
7 2
4
Summary of Contents for CT-400
Page 27: ...27 Note ...
