Assembly
3062.72-01 Rev. A
S e i t e
|
20
Observe the following instructions when installing the drive
system:
CAUTION! Risk of malfunctions and unexpected start-up of the drive system. Serial or
parallel wiring of several drives leads to malfunctions when teaching-in the radio remote
control. Connect each system separately.
All electrical installation work must only be carried out by a
qualified electrician.
Switch off all power supplies and carry out all electrical work
only in a voltage-free state.
Connect the motor to the power supply according to the circuit
diagram in Figure 5-4. Make sure that connection cable 2
(brown) is not connected.
Only connection cables that are suitable for the environmental
conditions and that meet all structural requirements must be
used.
If the drive system is not equipped with a connecting cable and
plug or other means of disconnection from the mains, which has
a contact opening width in each pole corresponding to the
conditions of overvoltage category III for full disconnection,
such a disconnecting device must be installed in the fixed
electrical installation in accordance with the installation
regulations.
The connection cables must not be mounted on surfaces that
heat up.
PVC cables are not suitable for equipment used outdoors or
exposed to elevated UV radiation for extended periods of time.
These cables must not be used if they are likely to come into
contact with metal parts whose temperature exceeds 70°C.
A plug for disconnecting the drive system from the mains must
be accessible after installation.
Secure the cabling against moisture intrusion and provide
sufficient strain relief for the cables.
Connecting cables with Hirschmann plugs are tested with
Hirschmann couplings and are approved by the motor
manufacturer.
Make sure that the mains voltage corresponds to the voltage
specified in the circuit diagram.
