Kett AN-920, Operating Manual

Page: 15 / 20

15
Procedure
(1) Press the [Setup] key.
(2) Press the [USER] key.
(3) Press the [Password change]
key.
(4) Enter the current password. Enter
the password (4 digits), and then
press the [Enter ] key. The new
passcord will be registered.
* At the time of shipment, "0000" is set.
Procedure
(1) Perform step (1) and (2) of the
"(1) Changing the passcord".
(2) Press the [Add user] key.
(3) Enter the ID (2 digits) and pass-
cord (4 digits), and then press the
[Enter ] key. The new user will
be registered.
* If the ID already exists, it will
overwrite the existing one.
(1) Changing the password
* Available only for Administrator
(2) Adding a user
* Available only for Administrator
Measurement
Calibration
curve selection
Bias
adjustment
Display
setting
Date&Time
setting
Communica-
tion setting
Light intensity
resetting
User addition
Administrator
◯ ◯ ◯ ◯ ◯ ◯ ◯ ◯
User
◯ ◯ ◯ ◯ ◯ ◯ ◯ －
Guest
◯ － － － － － － －
(3) Switching the user
Procedure
(1) Perform step (1) and (2) of the
"(1) Changing the passcord".
(2) Select the type of the user.
(3) Enter the ID (2 digits) and pass-
cord (4 digits), and then press the
[Enter ] key. The user will be
switched.
• When Administrator is selected,
ID is fixed with "01".
• When Guest is selected,
ID and password are not
required.
* To switch to Administrator or User
from Guest, the ID and
passcord
will be required.
● User switching [USER]
This unit has a different levels of operation depending on the user types (Administrator/User/Guest).
At the time of shipment, "Administrator" is set in which all operations are enabled.
Switch the user as required.