10
Measurement method
Remarks
About adjustment
How to fill the sample grain
(4) The last selected sample name is
highlighted. Press the sample
name in the list to measure.
(5) The selected sample is set and
the initial screen will be restored.
Press the [MEASURE] key.
(6) Empty the measurement chamber.
5. EASY OPERATION GUIDE
(7) Close the cover with the empty
measurement chamber. Then,
press the [NEXT] key.
(8) The measurement is in progress.
* Never open the cover.
* Install the unit at least 10 cm away
from the walls so that the ventilation
openings are not blocked.
* Turn on the power approximately one
hour before starting measurement and
warm up
the unit.
* To measure the temperature of a
sample, a thermosensor is inserted
into the sample case through the hole
provided at the bottom during meas-
urement. To obtain better accuracy, it
is recommended to keep the tempera-
ture of the sample and the environ-
mental temperature close.
* Clean the sample case. If the window
of the sample case is not clean or
significantly scratched, adjustment or
measurement may not be performed
correctly. If significantly scratched,
replace the the case.
(3) Press the sample name.
(1) Connect the main unit and the
power cable.
* Make sure to ground the power cable.
If grains are not filled tightly in the
sample case, a measurement error may
occur. Fill the grains tightly in the sam-
ple case as much as possible.
Tips
(1) Fill the grain so that the window of
the sample case is covered.
(2) Tap the bottom of the case hard
approximately 10 times so that
grains are tightly filled.
If rooms are made, fill more grain.
Repeat this tapping and filling as
required.
To use the unit properly, it is necessary
to set up the unit either automatically or
manually. (
⇒
Refer to P.12.)
(2) Turn on the power switch provid-
ed in the rear side of the main
unit.
Power supply
connector
Power switch
Power cable
Ground
Outlet
