Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Deutschland
9
it is too easy or too difficult to move the quick release lever, ti
2. Bicycles with Quick Release Axle
Remove the quick release from the bike and guide it through the hitch along with the quick release
axle.
Push the quick release through the wheel hollow axle again, screw the nut and clamp the quick release
with the correct pressure.
In order to ensure that the hub is clamped sufficiently in the hollow axle, the quick release lever must
begin gripping as it moves from the open to the middle position, and approaching the closed position
you should clearly feel resistance as you tighten.
If it is too easy or too difficult to move the quick release lever, tighten or loosen the quick release nut on
the other side of the hub.
WARNING
: The thread of the quick release nut must be tightened on the quick release axle by at least 5
full turns, so that adequate clamping force is ensured.
A quick release axle with is too short can result in accidental loosening of the rear wheel and therefore
cause serious injury or death.
If in doubt, contact your specialist dealer.
Insert the safety pin through holes in both hitch and hitch connectors. Rotate and lock up the pin.
Wrap the safety strap around the chain stay and fasten it to the tow bar D-ring with the snap hook.
WARNING
! Hitch and safety strap must be properly installed. Inspect the hitch and tow bar frequently
for any damage or loose fasteners. Damaged or improperly installed can result in serious injury or death.
Loading and Unloading pets
