Kessel Control Unit Ecolift 230V, Instructions For Installation, Operation And Maintenance

Page: 33 / 120

33/120 2016/02
GENERAL INFORMATION
4. Operation
4.1. Switching on
Connect to the mains voltage, following a successful system test
menu 0 System info appears in the display <39> and
the green LED <26> lights up, the control unit Ecolift
Comfort is ready for operation.
4.2. Acknowledging the alarm
Alarm message in normal operation
If a state occurs which triggers an alarm
(e.g. fault on the pump, level of the wastewater
reaches alarm level), this is indicated as follows:
- Alarm LED <27> lights up.
- If appropriate fault message on the display.
- Acoustic alarm.
The acoustic alarm can be switched off by pressing the key <28>
(approx. 1 second). After
elimination of the reason for the alarm, the alarm message
can be acknowledged by pressing the key <28> (for at least 5 seconds).
Alarm message in the event of a power outage
A power outage is detected by the control unit. The battery supply
of the control unit then triggers an alarm message. At the same time, the
acoustic alarm is sounded. The symbols shown appear on the display.
If no operation is carried out on the control unit, the display is switched
off after one minute to save the battery. Pressing any key (approx. 1 second)
switches the display back on again.
The acoustic alarm can be switched off by pressing the key <28> (approx. 1 second).
4.3. Maintenance
If the wording maintenance date appears on the display, carry out maintenance and then enter a new maintenance
date (see 6.1).
4.4. Switching off
• Disconnect the mains supply, the acoustic alarm sounds and the alarm LED flashes.
• Switch the acoustic alarm off, to do this press key <28> (Fig. [14]) (approx. 1 second) until the alarm symbol
appears crossed out on the display.
• Switch the control unit off, to do this keep key <28> pressed (at least 5 seconds) until the display and the alarm
LED are switched off.
The Ecolift control unit is switched off.
Ecolift
26
27
28
39
[14]
[15]