20
Betrieb DesignBase-Down/ Operation
5.2
Performing a Position Reset Procedure
When starting up the operating system for the first time, a reset is required. Through the reset,
e.g. with a table, all columns are brought to the same level in the middle table position. This
ensures that the table top moves parallel to the ground. In addition, the standard version of the
control system saves the number and type of connected components (columns) and any
connected sensor. A&er the reset, configuration changes are detected and classified as errors.
The system will not move until the saved state is restored.
Before using the LifeUP You System a Position Reset Procedur must be carried out.
You do this as follows:
1. Exit the energy-saving mode of the control system by briefly pressing the
UP
or
DOWN
button.
2. Hold down the
UP
and
DOWN
buttons at the same time. A&er approx.
3 seconds
, the reset
starts. Keep the buttons pressed until the reaching of the reset position is confirmed by a
double clicking sound from the control system.
3. Now release the buttons.
·
The reset position of the drives is located approx. in the middle of the
stroke.
·
The reset position depends on the traversing range and the attachments
of the table.
·
If the table is located above the reset position, the table first moves below
the reset position and then from below up to the reset position.
·
If the table is located below the reset position, the table moves up to the
reset position.
·
If one column of the table is located above the reset position and the
other column is located below the reset position, the column which is
above the reset position first move below the reset position. Then both
columns are moved from below to the reset position.
·
Each column performs its own reset. This means that if one column is
pushed in further than the other, the column will reach the reset point
sooner and will complete the reset sooner than the other column.
Notice
Summary of Contents for LifeUP You
