Kersten WKB 60 M-U 70, Original Operating Manual

Page: 13 / 19

English
13
8 Disassembly
•
Observe the information in the operating instructions of the carrier vehicle!
•
There is a risk of injury when disconnecting. Special caution is advised!
•
When decoupling the attachment unit, proceed as follows:
1. Stop the internal combustion engine.
2. Place the tractor on the support stand.
3. Loosen the star handles (3: L).
4. Raise the locking lever (2: J) and fold the lever upwards to lock it.
5. Pull the attaching unit forward and look for the clutch follower (2: I).
9.0 Service
9.1 Adjusting the brush
9.1.1 General information
•
The working height of the brush holder is adjusted via the trailing support wheel (1: B). The
working height depends on the position of the brush holder (1: F) and on the wear rate of the
brushes (1: H).
•
The position of the plate depends, among other things, on the strength of the wild boulder. The
operating range of the brush holder is shown in figure (4: M). Good working performance is
achieved when viewed in the direction of travel, the brush plate is inclined to the right and
slightly backwards.
•
After rainfall and wet weather, particularly good results are achieved.
•
The driving speed depends on the strength of the wild boulder.
9.1.2 Tilt adjustment of the brush holder
•
The inclination angle adjustment of the brush holder is via the spindles (6: C and 6: D). The
spindle (6: D) pivots the brush holder to the side of the direction of travel. The spindle (6: C)
pivots the brush plate forwards or backwards to the direction of travel.
•
Before the brush holder can be swiveled to the side of the direction of travel, loosen the
clamping lever (6: P).
•
After adjusting the brush holder, firmly tighten the clamping lever (6: P).