Kersten FKM 60, Operating Manual

Page: 26 / 76

2018-12-18 26 / 74
Front sweeper FKM 60
Security ENG
2.11 Safety instructions for maintenance / troubleshooting
Behavior in case of dangerous malfunctions
Basically:
1.
Immediately initiate emergency stop in the case of faults that pose an
immediate danger to persons or property.
2. Determine the cause of the fault.
3. If troubleshooting requires work in the hazardous area, switch off the
machine and secure it against being switched on again.
4. Have them repaired or repaired by authorized service personnel,
depending on the type of fault.
DANGER
Danger of life or injury due to improperly performed maintenance
work / work for fault elimination!
Due to improper maintenance / work for fault elimination, there is a risk of death or
injury as well as a risk of property damage to the machine or system!
•
Observe all safety information in this chapter as well as the relevant local
safety and accident prevention regulations.
• Only carry out interventions for troubleshooting and maintenance and
cleaning work if it is ensured that the machine is stationary and secured
against being switched on again.
• Release blocks only when it has been ensured that no dangerous
movement of machine parts occurs due to loosening.
• Ensure adequate assembly freedom before starting work.
• Pay attention to order and cleanliness at the installation site! Loose
components lying on or around each other and tools are accident sources.
• Wait until the oil has cooled to below 50 ° C before starting work.
• Before starting work, have a temperature-resistant collection container of
the required capacity.
• Observe the following before restarting:
•
Ensure that all work has been carried out and completed in
accordance with the instructions given in this manual.
• Make sure that there are no persons in the danger zone.
• Make sure all covers and safety devices are installed and
working properly.
• If components have been removed, ensure that they are
correctly installed. Reinstall all fasteners.