benchmarkwireline.com
P. O. BOX 850
Fax: 281.342.4848
Phone: 281.342.6415
Simonton,Texas 77476
36220 FM 1093
June-2007
Rev D
Page 9 of 18
4.4 OTHER
(OtH)
This menu is to be used if you have a measuring device with a
different wheel circumference than the standard Kerr
measuring devices.
No line size selections are available
The available menu selections in the OTHER menu are:
WHEEL CIRCUMFERENCE (Cr)
This setting represents the circumference of the measuring
wheel. Use the +/- switch to adjust the setting to match the
circumference of the measuring wheel you are using.
DEPTH ADJUST (Adj)
This setting is comparable to shimming a wheel. The amount
selected will automatically be added or subtracted from the
depth input. The values are feet / thousand.
DEPTH UNITS (UN)
This setting is used to set the display readout units to either
FEET or METERS.
DIRECTION (dir)
This setting is used to reverse the counting direction. The
depth should be increasing as you are going into the hole and
decreasing as you are coming out of the hole. If it is going the
opposite direction, use this setting to change it.
