11
ENGLISH
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest setting, the burner will
automatically start an autoclean procedure. The display will show the autocleaningcode
run-
ning back to
. The procedure takes 5 minutes, during which the heater will burn at its lowest
setting, while the burner autocleans. When the burner is clean again, the heater will automatically
switch back to the highest setting again.
TURNING OFF HEATER
While heater is burning, press power switch to “OFF” position. This will extinguish heater and ON/
OFF Lamp on the indicator panel will go out.
down heater.
NEVER: Turn heater off by disconnecting the heater plug from the main elecrical supply.
DO NOT: Restart your heater for at least ten minutes.
AUTOMATIC DEACTIVATION
This heater is fi tted with a safety system that ensures that it swiches off automatically after 50
hours continuous operation.
The following will then appear in the display:
. If desired, you can switch the heater on again
by pressing the button.
The circulation fan motor will operate further, for approximately 150 seconds to assist in cooling
THE USE OF THE MOTION DETECTION SENSOR
This heater is equipped with a motion detection sensor. The sensor
is placed at the front side of the heater and it signals every single
movement. The motion detection sensor has a horizontal detection
angle of 80° and a vertical detection angle of 20°. The sensor detects
movements as far as 7 m.
If the sensor does not detect movements for 10 minutes then the
heater will automatically switch to a lower combustion level. As a result
less fuel will be used.
Switch on the motion detection sensor;
Switching on the motion detection sensor can only be done when the
heater is turned on. Push the “Motion” button. A signal will sound and
the “Motion” light will light up (green).
If the sensor does not detect movements for 10 minutes then the
heater will automatically switch to a lower combustion level. The
motion detection sensor light keeps lighted up. If the sensor detects
movement the motion light will blink. The heater switches back to the
latest temperature setting.
Switch off the motion detection sensor;
The Motion detection sensor can be switched off by pressing the “Motion” button again. A sound
signal will be heard and the “Motion” light will go out.
11
ENGLISH
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest setting, the burner will
automatically start an autoclean procedure. The display will show the autocleaningcode
run-
ning back to
. The procedure takes 5 minutes, during which the heater will burn at its lowest
setting, while the burner autocleans. When the burner is clean again, the heater will automatically
switch back to the highest setting again.
TURNING OFF HEATER
While heater is burning, press power switch to “OFF” position. This will extinguish heater and ON/
OFF Lamp on the indicator panel will go out.
down heater.
NEVER: Turn heater off by disconnecting the heater plug from the main elecrical supply.
DO NOT: Restart your heater for at least ten minutes.
AUTOMATIC DEACTIVATION
This heater is fi tted with a safety system that ensures that it swiches off automatically after 50
hours continuous operation.
The following will then appear in the display:
. If desired, you can switch the heater on again
by pressing the button.
The circulation fan motor will operate further, for approximately 150 seconds to assist in cooling
11
ENGLISH
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest setting, the burner will
automatically start an autoclean procedure. The display will show the autocleaningcode
run-
ning back to
. The procedure takes 5 minutes, during which the heater will burn at its lowest
setting, while the burner autocleans. When the burner is clean again, the heater will automatically
switch back to the highest setting again.
TURNING OFF HEATER
While heater is burning, press power switch to “OFF” position. This will extinguish heater and ON/
OFF Lamp on the indicator panel will go out.
down heater.
NEVER: Turn heater off by disconnecting the heater plug from the main elecrical supply.
DO NOT: Restart your heater for at least ten minutes.
AUTOMATIC DEACTIVATION
This heater is fi tted with a safety system that ensures that it swiches off automatically after 50
hours continuous operation.
The following will then appear in the display:
. If desired, you can switch the heater on again
by pressing the button.
The circulation fan motor will operate further, for approximately 150 seconds to assist in cooling
11
ENGLISH
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest setting, the burner will
automatically start an autoclean procedure. The display will show the autocleaningcode
run-
ning back to
. The procedure takes 5 minutes, during which the heater will burn at its lowest
setting, while the burner autocleans. When the burner is clean again, the heater will automatically
switch back to the highest setting again.
TURNING OFF HEATER
While heater is burning, press power switch to “OFF” position. This will extinguish heater and ON/
OFF Lamp on the indicator panel will go out.
down heater.
NEVER: Turn heater off by disconnecting the heater plug from the main elecrical supply.
DO NOT: Restart your heater for at least ten minutes.
AUTOMATIC DEACTIVATION
This heater is fi tted with a safety system that ensures that it swiches off automatically after 50
hours continuous operation.
The following will then appear in the display:
. If desired, you can switch the heater on again
by pressing the button.
The circulation fan motor will operate further, for approximately 150 seconds to assist in cooling
11
ENGLISH
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest setting, the burner will
automatically start an autoclean procedure. The display will show the autocleaningcode
run-
ning back to
. The procedure takes 5 minutes, during which the heater will burn at its lowest
setting, while the burner autocleans. When the burner is clean again, the heater will automatically
switch back to the highest setting again.
TURNING OFF HEATER
While heater is burning, press power switch to “OFF” position. This will extinguish heater and ON/
OFF Lamp on the indicator panel will go out.
down heater.
NEVER: Turn heater off by disconnecting the heater plug from the main elecrical supply.
DO NOT: Restart your heater for at least ten minutes.
AUTOMATIC DEACTIVATION
This heater is fi tted with a safety system that ensures that it swiches off automatically after 50
hours continuous operation.
The following will then appear in the display:
. If desired, you can switch the heater on again
by pressing the button.
The circulation fan motor will operate further, for approximately 150 seconds to assist in cooling
11
ENGLISH
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest setting, the burner will
automatically start an autoclean procedure. The display will show the autocleaningcode
run-
ning back to
. The procedure takes 5 minutes, during which the heater will burn at its lowest
setting, while the burner autocleans. When the burner is clean again, the heater will automatically
switch back to the highest setting again.
TURNING OFF HEATER
While heater is burning, press power switch to “OFF” position. This will extinguish heater and ON/
OFF Lamp on the indicator panel will go out.
down heater.
NEVER: Turn heater off by disconnecting the heater plug from the main elecrical supply.
DO NOT: Restart your heater for at least ten minutes.
AUTOMATIC DEACTIVATION
This heater is fi tted with a safety system that ensures that it swiches off automatically after 50
hours continuous operation.
The following will then appear in the display:
. If desired, you can switch the heater on again
by pressing the button.
The circulation fan motor will operate further, for approximately 150 seconds to assist in cooling
10
Summary of Contents for LC-54
