7 Functions of display unit
7.1
Multiple range display
The size of the display steps depends on the measured weight:
from 0 to 200 kg the weight is displayed in 0.2 kg;
from 200 to 500 kg the weight is displayed in 0.5 kg;
from 500 to 2200 kg the weight is displayed in 1 kg.
Because of this weight-dependant size of the display step it is possible to weigh
smaller weights with more exactness. The display step does not change during
weighing. If e.g. a weight of 650 kg is weighed, the display step will not change to 0.5
kg, if the weighed quantity reaches 500 kg. The weight will continue to be displayed
in 1 kg-steps.
7.2
Prior to weighing: ZERO-POINT CHECK
Prior to each weighing process ensure that the system is unloaded and clear of
obstructions. The display unit provides automatic zero adjustment. This means, that
small deviations from the zero-point are corrected automatically. If the display unit
does not correct the zero-point automatically you will have to carry out a manual
correction with the help of the
key.
7.3
Gross weighing
After the load was lifted, the display shows the gross value of the weighed weight.
7.4
Net weighing: TARING BY PRESSING A BUTTON
The display unit offers an option that allows tare weights to be reset to zero by
pressing a button. In this way net weight changes can be traced. After taring, the
display unit will once again start at the smallest display step.
Ö
Lift the load.
Ö
Press button
(
)
PRE-
.
The display unit shows zero.
The lit up display “NET“, indicates that a tare weight is active.
Ö
Loading and unloading the net load.
The net value for the weighed weight is shown on the display.
For unloading this will be a negative value.
Ö
By actuating the
(
)
PRE-
button the gross weight can be read.
VHT-BA-e-0910
13
