2-4
TBC OPR 071019
FIGURE 2-3. TBC REAR PANEL
2.3
AC SOURCE POWER REQUIREMENTS
The TBC Battery Charger Power Supply is supplied for operation on a single phase line with a-c
input voltage between 100V and 250V a-c nominal (universal a-c input). The circuit breaker
remains effective at all input voltages.
WARNING: Input current may be hazardous. Refer to Table 1-2 for input current specifi-
cations and ensure source power is off and TBC Power ON/OFF is set to OFF
before proceeding.
a. Remove the four screws from the small panel located on the right side of the TBC Bat-
tery Charger rear panel.
b. Insert the AC power line through the hole in the panel; tighten the cable clamp and con-
nect the line, neutral and ground wires to their respective terminals on the Terminal
Block (see Figure 2-4).
c. Fasten the panel in place on the TBC Battery Charger rear panel.
